02-03-2021, 07:06 AM
Allright, thank you! I thought I did that "gc()" call and it just had a small effect.
To describe the workflow:
1. Loading a model with file size arround 200 to 500 MB (pure Mesh Data, no Shading, no Animation)
2. Collapsing all single parts to one mesh
3. Run tySelect in Raycast Mode, parsing arround the object over a couple of frames (takes several minutes)
5. Add MeshSelect modifier to invert the selection
6. Add DeleteMesh modifier to delete the selected faces
7. Add MeshSelect modifer to leave subselection mode
8. Add EditNormal modifer to reset the normals (clean up)
9. Collapse the stack
10. Save the file
11. Reset Max
12. Repeat steps 1 to 11 for approx 5 to 10 times
--------------------
13. Memory usage now is close to my installed 64GB
14. Memory overflow during the next automatic adaptive tySelect baking procedure
15. 3dsmax hard crash to desktop with "Unexpectd exception message", "Recovery File Saving" and "CER"
But I will try this "gc()" again.
To describe the workflow:
1. Loading a model with file size arround 200 to 500 MB (pure Mesh Data, no Shading, no Animation)
2. Collapsing all single parts to one mesh
3. Run tySelect in Raycast Mode, parsing arround the object over a couple of frames (takes several minutes)
5. Add MeshSelect modifier to invert the selection
6. Add DeleteMesh modifier to delete the selected faces
7. Add MeshSelect modifer to leave subselection mode
8. Add EditNormal modifer to reset the normals (clean up)
9. Collapse the stack
10. Save the file
11. Reset Max
12. Repeat steps 1 to 11 for approx 5 to 10 times
--------------------
13. Memory usage now is close to my installed 64GB
14. Memory overflow during the next automatic adaptive tySelect baking procedure
15. 3dsmax hard crash to desktop with "Unexpectd exception message", "Recovery File Saving" and "CER"
But I will try this "gc()" again.