05-30-2022, 10:13 AM
Thanks, understood. Wanted to use tyweld to weld overlapping faces and then wanted to load into birthflow just to add displace detail only to specific IDs. But found a solution for that.
Thanks ?
Thanks ?
|
Not inheriting uvw
|
| Messages In This Thread |
|
Not inheriting uvw - by Abhilash - 05-27-2022, 08:15 AM
RE: Not inheriting uvw - by tyFlow - 05-27-2022, 01:19 PM
RE: Not inheriting uvw - by Abhilash - 05-27-2022, 02:07 PM
RE: Not inheriting uvw - by tyFlow - 05-30-2022, 02:50 AM
RE: Not inheriting uvw - by Abhilash - 05-30-2022, 10:13 AM
|