First test, and few questions
#4
Maybe instead of the age test, use a Property Test and have it test the particle velocity, so it doesn't get sent to the next event until it's near the velocity you want. Then in the Property Test "timing" rollout, set the timing to match whatever your age test settings were.

As for particle chasing...that's a tough one because as you see there are some situations where particles can't travel fast enough, based on your settings, to close the gap necessary to reach the surface. You could try adding a surface force with a small distance/falloff, to give them an extra boost towards the surface when they get close...make the distance/falloff very small so it only affects particles near the surface. That might help that snap to it better, in a smooth way.
  Reply


Messages In This Thread
First test, and few questions - by d4rk3lf - 04-03-2019, 09:53 AM
RE: First test, and few questions - by tyFlow - 04-03-2019, 02:59 PM
RE: First test, and few questions - by d4rk3lf - 04-03-2019, 05:42 PM
RE: First test, and few questions - by tyFlow - 04-03-2019, 07:02 PM

Forum Jump: