How to make Cloth bind tearing delay?
#1
Hello every one
I have a question about tearin
As i show you in the file below
I have a flag that i wanna tear it
But i need some frame wind blowing on flag and after that the flag start to tearingĀ 
But as in the file, after flag touching the box ( surface test to activate cloth bind) the flag goes to start tearing
How can i make a delay for start tearing


Attached Files
.max   ersal dar group.max (Size: 992 KB / Downloads: 205)
  Reply
#2
Looks like you forgot to upload....don't forget to press the "Add attachment" button after choosing the attachment.
  Reply
#3
(05-02-2019, 02:36 AM)tyFlow Wrote: Looks like you forgot to upload....don't forget to press the "Add attachment" button after choosing the attachment.

Thank you
Yes that was my fault
Now attachment added
Please take a look
  Reply
#4
You can use a Modify Particles operator to set tearing ability on particles. So enable tearing in the Cloth Bind operator so that the cloth is setup to allow for tearing, then enable/disable it again in a Modify Bindings operator to match the timing you want.
  Reply


Forum Jump: