+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: Bugs and Issues (https://forum.tyflow.com/forum-3.html)
+--- Thread: birth spline (/thread-1188.html)
birth spline - joe_coke - 10-10-2019
the start & end spinners in the birth spline operator don't seem to work as i expected. Start does change the birth on frame but end does seemingly nothing, as all particles are birthed on the start frame. Should this give a gradual birth between start & end?
RE: birth spline - joe_coke - 10-10-2019
ignore this, i'm being a dick.