+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: Bugs and Issues (https://forum.tyflow.com/forum-3.html)
+--- Thread: tySelect update bug? (/thread-1224.html)
tySelect update bug? - insertmesh - 10-23-2019
hey there,
have a simple setup here with morpher activated by tySelect with decay.
I have to disable the tySelect below the morpher, so the vertex selection gets updated in morpher.
Also it only updates the selection then up to the frame where I disable/enable tySelect.
Not sure if thats a problem with tySelect or morpher...
RE: tySelect update bug? - tyFlow - 10-23-2019
Already fixed in the next build
RE: tySelect update bug? - insertmesh - 10-23-2019
Sweet!
RE: tySelect update bug? - insertmesh - 10-30-2019
There might be another bug: I have a scene with two tyselects on highpoly meshes with additive selection enabled.
I have pointcached both meshes above the tyselect (and morpher above that) and then disabled the modifiers below.
Yet, when I save and reopen the scene, tyselect starts baking the selection, before loading the scene fully.
If I disable additive selections before saving, it doesn´t update when reopening the scene.
RE: tySelect update bug? - tyFlow - 10-30-2019
It's baking the selection even though the tySelect is disabled?
RE: tySelect update bug? - insertmesh - 10-30-2019
Yep. Exactly.
RE: tySelect update bug? - tyFlow - 10-30-2019
That's odd...I'll look into it
RE: tySelect update bug? - insertmesh - 11-01-2019
Fixed in the latest build...