+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: Random radius with tyspline mesher ? (/thread-1351.html)
Random radius with tyspline mesher ? - oumoumad - 12-18-2019
I was wondering if there is a way to variate the tySplineMesher radius with something other than the length of the spline ? Maybe some custom data retrieved from particles?
Same thing for the tySplineExtrude, I would love to be able to variate the extrude amount based on any arbitrary data.
RE: Random radius with tyspline mesher ? - tyFlow - 12-18-2019
tySplineMesher > "Multiply by knot radius". Then adjust the size of your particles to match your desires radii.
RE: Random radius with tyspline mesher ? - oumoumad - 12-18-2019
I totally missed that one... thank you !
RE: Random radius with tyspline mesher ? - oumoumad - 12-18-2019
I check "Inherit Material ID" but it gets unchecked alone each time for some reason