+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: Feature Requests (https://forum.tyflow.com/forum-4.html)
+--- Thread: tySplineMesher Taper by lenght relative to value (/thread-1847.html)
tySplineMesher Taper by lenght relative to value - TubeSmokeGuy - 07-20-2020
Hi!
Can you please add a mode for "taper by length", that doesn't depend on the individual total lenght of each spline?
Simple example:
When I have 2 splines with different length' - let's say the first one is 1 meter and the second one 2 meters.
Currently the taper evaluates its full effect to the radius over the total lenght of each indiviual spline.
So spline 1 reaches its full taper after 1 meter and spline 2 after 2 meters.
But I want that the taper evaluates constant per lenghts so that for every spline after 1 meter the same radius is reached.
Independet of the individual total lenght of each spline.
I hope it's clear what I mean
.Greetings!
RE: tySplineMesher Taper by lenght relative to value - tyFlow - 07-23-2020
I can make a note about that in the roadmap, sure.
RE: tySplineMesher Taper by lenght relative to value - TubeSmokeGuy - 07-24-2020
Thank you! Very nice!