+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: Cloth sticking to collider when using maps? (/thread-2226.html)
Cloth sticking to collider when using maps? - louvfx - 02-18-2021
Hi,
I had unpredictable results using tyslicer, so I am using a texture map to make a controlled tear. The maps work great however the cloth always sticks to the collider.
(see image)
https://pasteboard.co/JOWLWRC.png
![[Image: JOWLWRC.png]](https://pasteboard.co/JOWLWRC.png)
I have the TIME STEP set to 1/4 or 1/6 frame and set up the cloth tear as usual. Any suggestions?
Thanks!,
Lou
RE: Cloth sticking to collider when using maps? - tyFlow - 02-18-2021
Are you using the CCCS?
RE: Cloth sticking to collider when using maps? - louvfx - 02-19-2021
(02-18-2021, 04:36 PM)tyFlow Wrote: Are you using the CCCS?
No, I never installed the cuda dlls. Is that my solution?
Ok, that was it. Once installed, it worked perfectly.
Much appreciated,
Lou
RE: Cloth sticking to collider when using maps? - tyFlow - 02-19-2021
Yea, the CCCS is tyFlow's accurate cloth collision method...all of its alternatives (Particle Physics op) will give sub-par results or sticking artifacts like the ones you ran into.
RE: Cloth sticking to collider when using maps? - louvfx - 02-21-2021
Ok the problem returned when I applied "self Collisions" in the CUDA collision solver panel.
I've gone thru every possible settings that made any sense to me but the collider sticks to the cloth when Self collisions are enabled. Can you point me towards the correct workflow to eliminate this stickiness ?
https://pasteboard.co/JPjCMcN.png