Animation of scale operator value doesnt work - Printable Version +- tyFlow Forum (https://forum.tyflow.com) +-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html) +--- Forum: Bugs and Issues (https://forum.tyflow.com/forum-3.html) +--- Thread: Animation of scale operator value doesnt work (/thread-257.html) |
Animation of scale operator value doesnt work - cibine - 04-08-2019 When i animate the scale value to make particles dispapear or appear, the animation isnt taken account it only goes from 0 to 100 in 1 frame on particles, whatever is my animation duration. i can use interpolation to get more than 1 frame of animation, but 1- it doesnt take in account the animation curve i made in curve editor,it only interpolates from 0 to 100% in a weird way 2- the timing is only dependant on the interpolation slider, and absolutly not on the keyframe of the scale sliders. 3- the scale curve after reducing interpolation isn't straight at all, it goes for ex, from 100% to 5% in 1 frame and then slowly go down to zero, wich result in my geos going to lot of small geos in 1 frame ( like dots) and then disappearing... So reducing interpolation is really not a good solution. of course i have tried the different setting for animation of operator, none of them produce a good result, so here i stopped on the most obvious settings, scale set to abosulte keyframe offset sync set to event age timing set to continous, event age , particle age, whatever it doesn't change anything RE: Animation of scale operator value doesnt work - tyFlow - 04-08-2019 Not quite sure I understand what you're trying to accomplish, but the problem could be a bug. Send the file to support@tyflow.com so I can check it out please RE: Animation of scale operator value doesnt work - cibine - 04-08-2019 sent ! btw your work is awesome , i can't wait to have the fully final version ! RE: Animation of scale operator value doesnt work - cibine - 04-09-2019 ok everything is allright, I update to 0.16010 |