+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: Birth Flow shows not all particles (/thread-2610.html)
Birth Flow shows not all particles - Alexx31 - 09-04-2021
Hello,
which could be the reason, that my birth flow is not showing all particles?
All are exported, all have a mesh operator (which probably isn't even necessary), everything was also cached into a tyCache which shows all particles.
Just a note about the screenshots: Birth Flow and Flow Update reference "tyflow00_retimed", which is the same like the "tyflow001", I did not change them yet. It also doesn't make a difference which one I reference.
Attached screenshots,
thanks again
original particles:
flowupdate
comparison between both (what isn't highlighted is missing in the flow update)
flowupdate node
export particles and node graph
when I reference the tyCache in the BirthFlow and FlowUpdate, I can see lot of small crosses when "mark particles with no geo"enabled, which are at the places of missing geo
RE: Birth Flow shows not all particles - tyFlow - 09-06-2021
Can you please post the file(s)