+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: Chip ( french fry) bend until break? (/thread-2831.html)
Chip ( french fry) bend until break? - duncano - 01-07-2022
Hi, I woudl be masively grateful, if anyone can help me find a good solution for...Bending a big fat British chip, until it snaps ( breaks in half)...i need to see it slow mo while the chip ( fry) breaks ( tears)....it will reveal soft mash potato inside ( which i will probably do in Pheonix...or at least i can probably figure that bit out).
ive attached a rough of the kind of movemnt.
Im thinking cloth, as it needs to be 1 solid mesh at start, but i cant seem to simulate hte required force needed to do it...it needs to bend and then tear.
thanks for your time, any suggestions would be awesome.
could i perhaps rig the chip (french fry) and have the cloth tear at some point...
or should i perhaps think fracturing the chip, and using tyskin?
Duncan