+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: Bugs and Issues (https://forum.tyflow.com/forum-3.html)
+--- Thread: tyMeshToSplines - Optimize Result (/thread-3687.html)
tyMeshToSplines - Optimize Result - betamax - 05-30-2023
Does the 'Optimize Result' feature require 'Weld Knots' checkbox to be enabled?
If so, then would it make sense to grey out/group that feature unless 'Weld Knots' is enabled?
This feature is also refered to incorrectly as 'Optimize Splines' in the documentation:
https://docs.tyflow.com/tyflow_modifiers/tyMeshToSplines/
RE: tyMeshToSplines - Optimize Result - tyFlow - 05-30-2023
Thanks for bringing those to my attention. You're correct: optimize shouldn't be enabled unless weld is enabled. I'll also correct the documentation at some point.
RE: tyMeshToSplines - Optimize Result - betamax - 05-30-2023
Thank you Tyson!