+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: About the difference between mesh operators and spline paths (/thread-3793.html)
About the difference between mesh operators and spline paths - masa - 07-30-2023
ちょっと気になったので質問させていただきます。メッシュ オペレータはシミュレーションのオン/オフに影響しませんが、スプライン パスの再シミュレーションは避けられないのでしょうか?
もう一つ、同じフロー内の異なるイベントのスプラインパスを別々に書き出すには、各イベントにエクスポートオペレータを入れて書き出せば良いのではないかと思ったのですが、結果的にはフロー内のスプラインパスが全て書き出されてしまいます。それは行われました。
これを行う良い方法はありますか?
ありがとう。
RE: About the difference between mesh operators and spline paths - tyFlow - 07-30-2023
This is an English forum…
RE: About the difference between mesh operators and spline paths - masa - 07-31-2023
(07-30-2023, 09:12 PM)tyFlow Wrote: This is an English forum…
Sorry, it was translated automatically.
Mesh operator doesn't affect simulation on/off, but re-simulation with spline path on/off is unavoidable?
Another thing, in order to separately export the spline paths of different events in the same flow, I thought that it would be better to put an export operator in each event and write it out, but as a result the spline path in the flow is all written out. this
Is there a better way to go?
thank you.