+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: How can i get these family bind to be stiffer? (/thread-4047.html)
How can i get these family bind to be stiffer? - ldotchopz - 01-22-2024
I am trying to get stiff cable like physics but they droop down at the base when simulated, I am using surface test, object bind, particle bind (family bind) to get this but the stiffness doesn't go up enough, and i cannot seem to make any difference using modify bindings, more steps etc. is there some way to have the object bind effectiveness phase out like a soft selection?
Thanks
RE: How can i get these family bind to be stiffer? - tyFlow - 01-22-2024
Have you tried angle binds after your assign your initial bind constraints? That will maintain the initial angle of the particles/binds better, resulting in less of a steep drop off to the sides.
RE: How can i get these family bind to be stiffer? - ldotchopz - 01-22-2024
(01-22-2024, 08:53 PM)tyFlow Wrote: Have you tried angle binds after your assign your initial bind constraints? That will maintain the initial angle of the particles/binds better, resulting in less of a steep drop off to the sides.
That worked great, thank you!