+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: Birth Flow from a Tyflow with Cloth - possible? (/thread-4436.html)
Birth Flow from a Tyflow with Cloth - possible? - Alexx31 - 09-05-2024
Hello,
I have a Tyflow Cloth setup, which is simulating until frame 50 to get ready then to work with it.
1.) My main question:
I would like (as known from prefracturing workflows) to import it just at that frame into another Tyflow, but this did not work.
- is it possible for cloth, maintaining all attributes?
Or should I export as geometry and then convert again to cloth?
(attached screenshots)
2.) simple question:
Where can I adjust later in the simultion the "length bias"?
I searched in Modify bindings but I see it only in the Cloth Bind as an option.
Thanks for help
RE: Birth Flow from a Tyflow with Cloth - possible? - tyFlow - 09-06-2024
You can't import cloth from one flow to another and maintain the cloth attributes, no.
The length bias is just a multiplier on the starting length of bindings. The Modify Bindings operator has the ability to multiply this value further, yes.