+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: How to make Cloth bind tearing delay? (/thread-513.html)
How to make Cloth bind tearing delay? - Sm3691 - 05-01-2019
Hello every one
I have a question about tearin
As i show you in the file below
I have a flag that i wanna tear it
But i need some frame wind blowing on flag and after that the flag start to tearing
But as in the file, after flag touching the box ( surface test to activate cloth bind) the flag goes to start tearing
How can i make a delay for start tearing
RE: How to make Cloth bind tearing delay? - tyFlow - 05-02-2019
Looks like you forgot to upload....don't forget to press the "Add attachment" button after choosing the attachment.
RE: How to make Cloth bind tearing delay? - Sm3691 - 05-03-2019
(05-02-2019, 02:36 AM)tyFlow Wrote: Looks like you forgot to upload....don't forget to press the "Add attachment" button after choosing the attachment.
Thank you
Yes that was my fault
Now attachment added
Please take a look
RE: How to make Cloth bind tearing delay? - tyFlow - 05-06-2019
You can use a Modify Particles operator to set tearing ability on particles. So enable tearing in the Cloth Bind operator so that the cloth is setup to allow for tearing, then enable/disable it again in a Modify Bindings operator to match the timing you want.