+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: Bugs and Issues (https://forum.tyflow.com/forum-3.html)
+--- Thread: Birth surface not updated (/thread-535.html)
Birth surface not updated - HHbomb - 05-03-2019
Hi,
Create a line and add "normalize spline" on it with "show knots" with a good distance value to have multiple knots.
Use this line as a "Birth surface" with "All vertices", display as "geometry"
Now we have a cross at each knot.
Change distance value in "normalize spline", particles are not updated. Need to remove and add line again.
RE: Birth surface not updated - tyFlow - 05-06-2019
If a sim doesn't update for whatever reason (some plugins and objects don't send proper reset notifications, so tyFlow doesn't know that a change has occurred), just right-click in the editor and choose "refresh simulation".
RE: Birth surface not updated - HHbomb - 05-13-2019
(05-06-2019, 01:56 AM)tyFlow Wrote: If a sim doesn't update for whatever reason (some plugins and objects don't send proper reset notifications, so tyFlow doesn't know that a change has occurred), just right-click in the editor and choose "refresh simulation".
OK ! Thanks