+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: How to "fade in" forces on a per-particle base? (/thread-891.html)
How to "fade in" forces on a per-particle base? - robertfreitag - 07-11-2019
Hello, I'm stuck with a problem I cannot figure out on my own. I'm trying to "fade in" a force.
Back in the Pflow days the force operator had a "offset influence" where you could "Sync by" for example particle age.
I cannot find any equivalent in TyFlow on my own.
So what I want is: Particles from event A are getting tested and sent into event B,
then I want the force in event B to successively add over a couple of frames for each individual particle, not for all at ones.
I did see the "timing" rollout but as far as I understand it, this only allows me to set the operator
"on" and "off" by for example event age or particle age.
Any tips would be helpful. Thanks!
-Robert
RE: How to "fade in" forces on a per-particle base? - tyFlow - 07-12-2019
Not possible yet outside of the Script operator, but you can see timing controls for operators is on the todo.