TyConform: add "relax over source geometry"

[Zemmu]

Hi,
tyconform is amazing, simple and powerful.
Something that would help a lot would be a "relax over source geometry", so we could have an even geometry, ready for tyflow cloth

[tyFlow]

Could you give an example of what you mean?

[Zemmu]

Something like toporelax: https://mariussilaghi.com/products/toporelax
Right now the conformed geometry hasn't an even geometry (I tried all modes), very dense areas mixed with areas with long edges and very few vertices.
I'd like the conformed geometry to "slide" over the destination geometry until edges lenghts are as much similar as possible.

[tyFlow]

That's a bit beyond the scope of what the tyConform mod is designed to do....perhaps you could stack 2 tyConforms and put the toporelax between them? So you'd get the relaxation but also a re-conform after that to keep the verts hugging the target surface.

[Zemmu]

That's a bit beyond the scope of what the tyConform mod is designed to do....perhaps you could stack 2 tyConforms and put the toporelax between them? So you'd get the relaxation but also a re-conform after that to keep the verts hugging the target surface.

I'll try!