07-29-2022, 04:56 AM
This reads very similar to the problem we are having over at this thread: https://forum.tyflow.com/thread-2782-pos...l#pid10579
Individually rendered frames render fine, but sequences don't. In my case it's the same as described here: "single" frame render works well, but "range" or "active time segment" or "frames" results in invisible TyFlow (as opposed to not updated TyFlow in this post). I had the problem with scanline and vray, so I think it's not an issue with a specific renderer. Somehow rendering a sequence does not work for us while single frames are fine with no obvious cause in sight (I tried to eliminate causes by switching pretty much any parameter, but no success). I hope there is a solution.
Individually rendered frames render fine, but sequences don't. In my case it's the same as described here: "single" frame render works well, but "range" or "active time segment" or "frames" results in invisible TyFlow (as opposed to not updated TyFlow in this post). I had the problem with scanline and vray, so I think it's not an issue with a specific renderer. Somehow rendering a sequence does not work for us while single frames are fine with no obvious cause in sight (I tried to eliminate causes by switching pretty much any parameter, but no success). I hope there is a solution.