Hi,
I would like to know if you can make an option to tyspline mesher mode.
There is "extrude", "mesh" ," trail", "tube".
It could be "arrow" : same as mesh but automatically add an arrow in direction of spline with size option.
Max yellow dot is furstrating when having lot of intricated splines.
Thanks !!!
I would like to know if you can make an option to tyspline mesher mode.
There is "extrude", "mesh" ," trail", "tube".
It could be "arrow" : same as mesh but automatically add an arrow in direction of spline with size option.
Max yellow dot is furstrating when having lot of intricated splines.
Thanks !!!