03-05-2024, 09:02 AM
Hello, I would like to ask because I don't know if it's a bug or if I'm using it incorrectly.
The angle step is set to 90 to rotate in 90 degree increments using the rotation operator. I tried turning off restrict divergence to axis to check this effect, but there was no change.
So I think this switch is currently not working.
Also, I don't think the step itself is working in random horizontal.
thanks.
The angle step is set to 90 to rotate in 90 degree increments using the rotation operator. I tried turning off restrict divergence to axis to check this effect, but there was no change.
So I think this switch is currently not working.
Also, I don't think the step itself is working in random horizontal.
thanks.