10-04-2019, 02:10 PM
Great job on tyselect, some ideas for improvements:
- softselection shoud be between -1 to 1 range and not clamp it. (So we can do pushes in both sides of a normal for example).
-In some situations tyselect is slower than volumeselect. I see using "mesh" as selection, if the mesh if very hires can be very slow. Converting the mesh to SDF and using it instead, we can have a faster tyselect, and have control about the quality of our selection.
-Selection accumulation overtime.
-Make use of all width on command pannel in max 2018 and over, it feels a little too saturated right now.
- softselection shoud be between -1 to 1 range and not clamp it. (So we can do pushes in both sides of a normal for example).
-In some situations tyselect is slower than volumeselect. I see using "mesh" as selection, if the mesh if very hires can be very slow. Converting the mesh to SDF and using it instead, we can have a faster tyselect, and have control about the quality of our selection.
-Selection accumulation overtime.
-Make use of all width on command pannel in max 2018 and over, it feels a little too saturated right now.