Can't get motion blur on TySplines (VRay)!

[William]

Unfortunately this is simply a current limitation of tyFlow. I hope to get all moblur issues worked out in the future, but I don't have an estimated timeline.

Some users have reported that exporting to XMesh will allow you to get motion blur. And It's also possible that if you set your VRay moblur interval to twice the duration it may work as well (ex: moblur duration of .25, interval to 0.5).

Thanks for the quick reply, I will try the interval first then look into Xmesh, hopefully one of those would work. 


I tried Alembic after meshing the splines but that didn't work out either, I find it difficult to understand why it wouldn't since the Velocity channels are already there and Mesher should in theory bake that velocity into the alembic. By the way Tmesher didn't work with Alembic for some reason so I used "Mesher" compound object.