12-05-2019, 06:32 PM
(12-05-2019, 10:12 AM)Zemmu Wrote: This question sparked from a question in the fb page by an user, where he asked if there was a way to "chip" only the external parts of an object (e.g. an ice cube) keeping the core intect.
I am fairly new to Tyflow but playing around, you might be able to use Voronoi + Particle Glue or PhyxGlue + Surface Test (and picking the object that's going to shave the ice) - There is also the Shell option... but I am not sure if that will give a desired look. I hope this gives you some more ideas to try out
