01-07-2020, 09:39 PM
(This post was last modified: 01-07-2020, 09:39 PM by shadowkiller.)
I tried that but i couldn't get it to work. Im not sure it is reading the mapping values with that. I set the timing to continuous but no luck. Could it be because my gradient ramp is being used in a mix material? I assigned the gradient to the operator.
I did mange to get the custom properties to readback the uvw mapping. I just havent managed to get the test to read that now. Tried using custom vector and custom vector magnitude in the test operator but that didnt work either.
I did mange to get the custom properties to readback the uvw mapping. I just havent managed to get the test to read that now. Tried using custom vector and custom vector magnitude in the test operator but that didnt work either.