08-20-2020, 04:08 PM
(This post was last modified: 08-20-2020, 04:10 PM by Don Corve.
Edit Reason: Image was a huge code, replaced it with a link!
)
Hey guys! 
First all all thanks to the developers that have worked hard to create this amazing tool!
I'm new to this forum and forums in general so please bear with me, I'm just starting to use this tool and I want to try to create a fracture effect that happens in a super slow motion, like those high speed camera footage.
One of the materials I wanna test for: Terracotta
Gyazo link
Below is my flow, the Physx retimer is set by speed, 7%
Workflow
The issue with the simulation now is that after collision, there is a delay of a few frames for the next event to come into effect, what am I missing?
Please share any feedback on the workflow or the effect!
Thank you!
First all all thanks to the developers that have worked hard to create this amazing tool!
I'm new to this forum and forums in general so please bear with me, I'm just starting to use this tool and I want to try to create a fracture effect that happens in a super slow motion, like those high speed camera footage.
One of the materials I wanna test for: Terracotta
Gyazo link
Below is my flow, the Physx retimer is set by speed, 7%
Workflow
The issue with the simulation now is that after collision, there is a delay of a few frames for the next event to come into effect, what am I missing?
Please share any feedback on the workflow or the effect!
Thank you!