(02-02-2021, 04:06 AM)d4rk3lf Wrote: Here's some thoughts:
- In addition to the surface test, you could use PhysX collision operator, and check particle collisions, so they activate themselves when sphere hits them
- Sometimes, in the scenario where sphere hits the wall, I just use time test operaor, and just send them to physX at the specific frame. Can't be simpler then that.
- Usual method that people do with Tyflow is that you add PhysX Bind operator, but check down that is breakable by force, and just lower your force strength to some low value (that way, PhysX Bind will keep them together, but it will be weak, so sphere will brake it). Also, it's good to check (if the wall is the object) ,that is also bind by ground.
I think I used this last method for this test:
https://www.youtube.com/watch?v=rCuuHIw4uhI
So, in conclusion, the most similar Tyflow option to Rayfire sleep is PhysX Bind operator, with brakable by force on, and with low values on the force.
Check out this tutorial too, for adding extra details
https://www.youtube.com/watch?v=rCuuHIw4uhI
Oh , OK I will give it a try.
Currently I have the dynamics being triggered on via Properties test / Velocity (anything greater than 0, test true) So once any pieces move slightly on impact, they move to the next event containing my dynamics which activate . My dilemma with that is the wall pieces can not move unless they ARE dynamic & collide turned on.(so they can't trigger the velocity Mag) Which defeats my original plan . So with my current setup, I had to turn off Gravity in TYFLOWS PROPERTY and add "force /gravity" into the events.
I feel like there is a much easier way to make the freaking wall activate, on impact other than my setup.
I am looking forward to trying your methods.
Thanks!