02-04-2021, 01:53 AM
Hi all,
Sometimes I need to isolate my dynamics using the Surface test (Inside Volume)
For example, I would use a large cube and cover just the portion of area I wish to isolate an event.
The common issue I run into is that the isolated area abruptly stops its influence where the cube stops. (see image sample)
https://pasteboard.co/JMJ02l5.png
So is there a way to control the STOP edges to make it gradually fade out its influence?
I tried Noise parameter but that doesn't help.
Thank you
Sometimes I need to isolate my dynamics using the Surface test (Inside Volume)
For example, I would use a large cube and cover just the portion of area I wish to isolate an event.
The common issue I run into is that the isolated area abruptly stops its influence where the cube stops. (see image sample)
https://pasteboard.co/JMJ02l5.png
So is there a way to control the STOP edges to make it gradually fade out its influence?
I tried Noise parameter but that doesn't help.
Thank you