|
How to set material for tyflow particles
|
05-24-2021, 07:47 AM
(This post was last modified: 05-24-2021, 08:22 AM by windwolfx23.)
Timing setting of operators are very important, set them to continuous if the data should be changed every frame(eg. cooling = temperature decreasing over time).
|
| Messages In This Thread |
|
How to set material for tyflow particles - by mikeup - 05-14-2021, 02:02 PM
RE: How to set material for tyflow particles - by tyFlow - 05-14-2021, 10:44 PM
RE: How to set material for tyflow particles - by mikeup - 05-15-2021, 02:45 PM
RE: How to set material for tyflow particles - by mikeup - 05-22-2021, 11:40 AM
RE: How to set material for tyflow particles - by mikeup - 05-23-2021, 08:21 AM
RE: How to set material for tyflow particles - by windwolfx23 - 05-24-2021, 07:47 AM
RE: How to set material for tyflow particles - by mikeup - 05-24-2021, 04:24 PM
|