08-20-2021, 06:49 PM
Save their position with a Custom Properties operator (timing set to entry), then restore it each frame with a Custom Properties operator retrieving the data from the channel you saved it to (timing set to Continuous). Then add a Stop operator above your force operator (timing set to continuous as well).
This will store an original location for your particles, and also restore that position each frame, and also clear out any assigned velocities on the prior frame. After those operators, add a Force operator with whatever noise settings you like. That setup will cause particles to jitter in place.
This will store an original location for your particles, and also restore that position each frame, and also clear out any assigned velocities on the prior frame. After those operators, add a Force operator with whatever noise settings you like. That setup will cause particles to jitter in place.