12-09-2020, 12:12 PM
ive not had very good results so far with getting nice motion blur on tyflow particles.. as i understand it currently tyflow only provides 2 samples for moblur irrespective of the number of subframe steps calculated.
this means straight lines for all moblur, which does not look very nice.
i also get the impression sometimes the motion vectors are not correct (the blur seems go in a slightly different direction to the motion, but that could be either the 2 sample blur or my imagination..
is it anywhere in the to-do list, or are there any work-arounds?
this means straight lines for all moblur, which does not look very nice.
i also get the impression sometimes the motion vectors are not correct (the blur seems go in a slightly different direction to the motion, but that could be either the 2 sample blur or my imagination..
is it anywhere in the to-do list, or are there any work-arounds?