TySelect - Curvature with Noise
The noise in the Gizmo mode adds implicit displacement to vertex positions. But the curvature mode doesn't measure from vertex positions...it's generates curvature info from vertex/edge/face adjacency info...so there's no way to add noise like that because position data isn't considered.

That said, you can always just layer some noise on top as a separate selection type, that subtracts from your initial curvature selection. Ex: a noise texmap selection.

Messages In This Thread
RE: TySelect - Curvature with Noise - by tyFlow - 03-17-2021, 08:05 PM

Forum Jump: