Birth and Delete Subframes
#1
Hi there,

Not sure if this feature is in already, but I'm trying to re-time my particle simulation to 5% speed in Tyflow and save them out as PRT with partitions.

The problem is that the particles pop on and off every 20 frames when they birth and die.

Is there a way to get my PRT partitions out without this problem?

Thanks
  Reply
#2
For that kind of extreme retiming, it's better to do your whole sim in slow motion rather than retime it after the fact.

Cache data is saved on whole frames only, to conserve memory, so tyFlow has no information about which subframe a particle is created on in the cache....so that's why you're not seeing them birth/die on frames 1-19 after retiming.
  Reply


Forum Jump: