Adding a curve pattern to the mapping operator Is it possible to switch the "normaliz
#1
HI´╝îTyson!

Adding a curve pattern to the mapping operator

Is it possible to switch the "normalize values" value to the curve mode, and adjusting the curve will be conducive to non-linear animation? Do you think this is feasible? thank you

Can the normalized value in the "mapping" operator be saved to a new channel? As a new channel value, you can use the attribute operator to read again.


Attached Files Thumbnail(s)
   
  Reply
#2
I'm not sure I understand the use case here....

And you can already copy map values between channels and then normalize them after. I think that would be equivalent to your second request...
  Reply
#3
Why should there be an output channel? The final result is that gradient gradient map is needed. However, in the attribute operator of tyflow, few attributes can be directly assigned to the map. Therefore, I think if the normalized value of the mapping operator can be output to a new channel again, this value can be applied to custom attributes.
=============================================================================
I mainly hope that the normalized value of the mapping operator can be represented by a curve.
  Reply


Forum Jump: