Surface test Volume inside gradient?
#1
Hi all,
Sometimes I need to isolate my dynamics using the Surface test (Inside Volume)
For example, I would use a large cube and cover just the portion of area I wish to isolate an event.
The common issue I run into is that the isolated area abruptly stops its influence where the cube stops. (see image sample) 
https://pasteboard.co/JMJ02l5.png

So is there a way to control the STOP edges to make it gradually fade out its influence?
I tried Noise parameter but that doesn't help.
Thank you
  Reply


Messages In This Thread
Surface test Volume inside gradient? - by louvfx - 02-04-2021, 01:53 AM

Forum Jump: