+- tyFlow Forum (https://forum.tyflow.com)
+-- Forum: tyFlow Discussion (https://forum.tyflow.com/forum-1.html)
+--- Forum: General Discussion (https://forum.tyflow.com/forum-2.html)
+--- Thread: tyconform offset question (/thread-1985.html)
tyconform offset question - HHbomb - 10-06-2020
Hi,
In tyconform z offset is relative to target surface normal ?
sometimes when I use raycast z=-1, and I set z offset, instead of moving out of the target surface it moves in x direction.
If I reset transform my target object, then it is ok.
But certainly there is some case where I cannot reset my object.
RE: tyconform offset question - tyFlow - 10-09-2020
If you have a replicable scene, please submit it.
RE: tyconform offset question - HHbomb - 10-12-2020
(10-09-2020, 01:10 AM)tyFlow Wrote: If you have a replicable scene, please submit it.
Hi,
Here is a scene. :-)
RE: tyconform offset question - tyFlow - 10-15-2020
Thank you for the scene...that is indeed a strange and unintended result, and I'll make a note to look into it further and hopefully get it fixed in the next build.
RE: tyconform offset question - HHbomb - 10-15-2020
(10-15-2020, 05:22 AM)tyFlow Wrote: Thank you for the scene...that is indeed a strange and unintended result, and I'll make a note to look into it further and hopefully get it fixed in the next build.
Thanks !