07-20-2020, 08:36 AM
Hi!
Can you please add a mode for "taper by length", that doesn't depend on the individual total lenght of each spline?
Simple example:
When I have 2 splines with different length' - let's say the first one is 1 meter and the second one 2 meters.
Currently the taper evaluates its full effect to the radius over the total lenght of each indiviual spline.
So spline 1 reaches its full taper after 1 meter and spline 2 after 2 meters.
But I want that the taper evaluates constant per lenghts so that for every spline after 1 meter the same radius is reached.
Independet of the individual total lenght of each spline.
I hope it's clear what I mean
.
Greetings!
Can you please add a mode for "taper by length", that doesn't depend on the individual total lenght of each spline?
Simple example:
When I have 2 splines with different length' - let's say the first one is 1 meter and the second one 2 meters.
Currently the taper evaluates its full effect to the radius over the total lenght of each indiviual spline.
So spline 1 reaches its full taper after 1 meter and spline 2 after 2 meters.
But I want that the taper evaluates constant per lenghts so that for every spline after 1 meter the same radius is reached.
Independet of the individual total lenght of each spline.
I hope it's clear what I mean
.Greetings!
