As shown in the figure below, the line generated between two particles is a "straight line" by default. Is it possible to make the line between particles an isolated line, or can a curve chart be used to control the direct intermediate form
|
Whether "tySplines" can generate Bézier curve
|
| Messages In This Thread |
|
Whether "tySplines" can generate Bézier curve - by cgdvs - 06-13-2023, 03:36 PM
RE: Whether "tySplines" can generate Bézier curve - by tyFlow - 06-15-2023, 02:18 PM
RE: Whether "tySplines" can generate Bézier curve - by cgdvs - 06-16-2023, 11:14 AM
RE: Whether "tySplines" can generate Bézier curve - by tyFlow - 06-16-2023, 02:54 PM
|