11-29-2023, 08:05 PM
So enabled clamping in the timing rollout but it still didn't do anything. however setting a negative offset did work. but i would prefer not to have to offset the animtion. Could you please explain how to get it to work with clamping?
I thought tylooper just used the last 15 frames to push the geo into the position of the start frame, i was not aware of it using negative frames. Because inversely if i set the looper to "loop at beggining" and there are hundreds of positive frames after frame 100, it still does not work.
So really i would need to use a start frame of 15 and a blend frames of 15 in tylooper to get thing to work correctly, or just have negative frames.
I thought tylooper just used the last 15 frames to push the geo into the position of the start frame, i was not aware of it using negative frames. Because inversely if i set the looper to "loop at beggining" and there are hundreds of positive frames after frame 100, it still does not work.
So really i would need to use a start frame of 15 and a blend frames of 15 in tylooper to get thing to work correctly, or just have negative frames.