09-06-2024, 02:53 PM
G'Day Tyson
If you create a spline with 3 segments. Then assign a material ID to each segment (1,2,3).
If you select Inherit Spline Material ID, the whole spline only gets the 1st's segments material ID applied to the whole spline.
IE: if the material ID of first segment is 1 then 1 is assigned to whole spline, if 4 then 4 is assigned to whole spline.
is this normal assignment of materials or should they match each segments set id ?
Thanks Mate
Rob
Correction to behavior - I just noticed the above is only true in Percent along spline and distance along spline
in knots mode the material ID is set as per original material assignment
If you create a spline with 3 segments. Then assign a material ID to each segment (1,2,3).
If you select Inherit Spline Material ID, the whole spline only gets the 1st's segments material ID applied to the whole spline.
IE: if the material ID of first segment is 1 then 1 is assigned to whole spline, if 4 then 4 is assigned to whole spline.
is this normal assignment of materials or should they match each segments set id ?
Thanks Mate
Rob
Correction to behavior - I just noticed the above is only true in Percent along spline and distance along spline
in knots mode the material ID is set as per original material assignment