Hello,
when I import tyCache into a Birth Flow operator with Flow Update, then I'm getting very different results.
The simulation has not more collision and seems to duplicate the particles at each frame.
Attached two screenshots comparing tyCache and the same tyCache imported into Birth Flow, both seen at the same frame.
(start frame is correctly 1001)
The issue shows up with only the birth flow operator (flow update deactivated), and is constanly importing new particles at each frame, ignoring "new particles only" and not doing any simulation.
I remember using always this workflow - did something change or did I miss something?
2.)
Is it possible to import a cached cloth simulation into a birth flow?
I tested to convert it with Cloth Bind operator, but it seems not possible.
Thanks
when I import tyCache into a Birth Flow operator with Flow Update, then I'm getting very different results.
The simulation has not more collision and seems to duplicate the particles at each frame.
Attached two screenshots comparing tyCache and the same tyCache imported into Birth Flow, both seen at the same frame.
(start frame is correctly 1001)
The issue shows up with only the birth flow operator (flow update deactivated), and is constanly importing new particles at each frame, ignoring "new particles only" and not doing any simulation.
I remember using always this workflow - did something change or did I miss something?
2.)
Is it possible to import a cached cloth simulation into a birth flow?
I tested to convert it with Cloth Bind operator, but it seems not possible.
Thanks