11-13-2019, 04:08 AM
Just align your particles to the surface/velocity however you like, then in the tySplineMesher settings choose knots as the orientation source.
|
the "tySplineMesher" itself axial.
|
| Messages In This Thread |
|
the "tySplineMesher" itself axial. - by cgdvs - 11-12-2019, 10:42 AM
RE: the "tySplineMesher" itself axial. - by tyFlow - 11-12-2019, 12:55 PM
RE: the "tySplineMesher" itself axial. - by cgdvs - 11-13-2019, 12:31 AM
RE: the "tySplineMesher" itself axial. - by tyFlow - 11-13-2019, 04:08 AM
RE: the "tySplineMesher" itself axial. - by cgdvs - 11-13-2019, 04:51 AM
|