Hello,
which could be the reason, that my birth flow is not showing all particles?
All are exported, all have a mesh operator (which probably isn't even necessary), everything was also cached into a tyCache which shows all particles.
Just a note about the screenshots: Birth Flow and Flow Update reference "tyflow00_retimed", which is the same like the "tyflow001", I did not change them yet. It also doesn't make a difference which one I reference.
Attached screenshots,
thanks again
original particles:
flowupdate
comparison between both (what isn't highlighted is missing in the flow update)
flowupdate node
export particles and node graph
when I reference the tyCache in the BirthFlow and FlowUpdate, I can see lot of small crosses when "mark particles with no geo"enabled, which are at the places of missing geo
which could be the reason, that my birth flow is not showing all particles?
All are exported, all have a mesh operator (which probably isn't even necessary), everything was also cached into a tyCache which shows all particles.
Just a note about the screenshots: Birth Flow and Flow Update reference "tyflow00_retimed", which is the same like the "tyflow001", I did not change them yet. It also doesn't make a difference which one I reference.
Attached screenshots,
thanks again
original particles:
flowupdate
comparison between both (what isn't highlighted is missing in the flow update)
flowupdate node
export particles and node graph
when I reference the tyCache in the BirthFlow and FlowUpdate, I can see lot of small crosses when "mark particles with no geo"enabled, which are at the places of missing geo