Testing (again) keys on birth rate, they actually are invisible... No chance to see in a quick check
and cumbersome to change.
I can see them only when I am coincidentally on the keyed frame, then there are short these red brackets.
No further information, even nothing visible in the timeline.
And if I would like to shift the birth frames (which is the case now with 8 differently event nodes), I can plan 15 minutes for a small task, to adjust them.
Because I have to jump now between max editors and birth rate and event frames. And if that was wrong I can do it all again...
( And this is only for one attribute in one operator, the "birth rate", I would like use them in many operators to refine the results.)
and cumbersome to change.
I can see them only when I am coincidentally on the keyed frame, then there are short these red brackets.
No further information, even nothing visible in the timeline.
And if I would like to shift the birth frames (which is the case now with 8 differently event nodes), I can plan 15 minutes for a small task, to adjust them.
Because I have to jump now between max editors and birth rate and event frames. And if that was wrong I can do it all again...
( And this is only for one attribute in one operator, the "birth rate", I would like use them in many operators to refine the results.)