tyMeshToSplines - Optimize Result

[betamax]

Does the 'Optimize Result' feature require 'Weld Knots' checkbox to be enabled?
If so, then would it make sense to grey out/group that feature unless 'Weld Knots' is enabled?

This feature is also refered to incorrectly as 'Optimize Splines' in the documentation:
https://docs.tyflow.com/tyflow_modifiers...ToSplines/

[tyFlow]

Thanks for bringing those to my attention. You're correct: optimize shouldn't be enabled unless weld is enabled. I'll also correct the documentation at some point.

[betamax]

Thank you Tyson!