On the Offset Problem of the "Array" Operator

[cgdvs]

Hi,Tyson!


Can the 'Array' operator add a negative offset? As shown in the figure, can you copy to "- X, - Y, - Z" in a certain axis?
Can there be an option to select "Mirror" mode when copying?
Thank you!

[tyFlow]

Did you forget an attachment? You mention "as shown in the figure" but there's no image...

[cgdvs]

I have repeatedly uploaded images, but there are no attachments in the end. I'm very strange.

https://www.facebook.com/photo/?fbid=157...1079090457

---

At present, 'Array_Z spread' can only enter positive values and cannot enter any negative values. I hope this value can be entered as a negative value.

[tyFlow]

Sure I will allow them to be negative in the next build.

As for the attachment...I was able to add it to this post without issue. Do you see an error message when you try to attach a file?

[cgdvs]

The prompt 'File upload failed. Please select a valid file and try again.'


https://www.facebook.com/vfxdvs/videos/8...&ref=notif

---

Sure I will allow them to be negative in the next build.

As for the attachment...I was able to add it to this post without issue. Do you see an error message when you try to attach a file?

Thank you.