Bug or Expected Behavior - Birth Spline ?

[rjanders0003]

G'Day Tyson

If you create a spline with 3 segments. Then assign a material ID to each segment (1,2,3).

If you select Inherit Spline Material ID, the whole spline only gets the 1st's segments material ID applied to the whole spline.

IE: if the material ID of first segment is 1 then 1 is assigned to whole spline, if 4 then 4 is assigned to whole spline.

is this normal assignment of materials or should they match each segments set id ?

Thanks Mate

Rob

Correction to behavior - I just noticed the above is only true in Percent along spline and distance along spline

in knots mode the material ID is set as per original material assignment

[tyFlow]

Hmm, I'll make a note to look into this.